To
select the interior tank alone (tank selector valve):
you need to open the access door found in
driver side rear bed shown in Picture G-P14. The interior tank is selected by moving the selector valve to
the interior tank position as shown in Picture G-P15.
Picture G-P15:
Tank selector valve location.
Valve is in the interior tank position.
Picture G-P14:
Location of the access door for the
tank selector valve.
To
isolate and drain the outside shower
when using the fresh water system in moderate subfreezing
conditions the shower cutoff valves must be closed.
To close the shower cutoff valves:
1.
Remove cushions from driver side rear bed.
2.
Open water heater access cover, see Picture G-P16.
3.
Locate the hot and cold water cutoff valves, see Picture G-P17.
4. To isolate the exterior shower faucets the cutoff valves must be turned 90
º
(cross line). Refer to
Pictures G-P18 and G-P19
for the open and closed positions of the isolator valves.
5.
Open the shower faucets in order to drain the exterior water lines (Reclose after draining exterior
tank).
6.
For summer use of the fresh water tanks repeat the steps in reverse.
NOTE:
When the water system is operating in the winter mode, only the interior fresh water tank
is to be used. Therefore you must be aware that the interior tanks fluid level is actually
empty when the 1/3 L.E.D. light is displayed on the monitor panel.
WATER SYSTEMS
Page G.10
Printed in Canada
Copyright
Hanmar Motor Corporation 2001
Doc No:
FMSA0002
Rev:
01
