8. Video Mute -
Press the FN button twice in one second (double click) to enable the video mute
function, when MUTE is on, the recorded video won’t have audio. When mute is enabled, the
camera will beep once, when mute is disabled the camera will beep twice.
9. Reset
– The reset button is located inside the USB port just below the cable port itself (there is
a small hole/indentation). Push the reset button.
**Please note before using the button that:
It is recommended to ONLY USE THE RESET
BUTTON ONLY WHEN THE CAMERA IS WORKING ABNORMALLY (i.e. THE CAMERA FREEZES) and
all other options have been tried.
After the Reset Button has been pressed, turn the camera off
then back on again and the camera should work properly. Data will be saved.
Voice Alarm
The camera will emit a voice alarm when;
1. When the camera is powered on the camera will emit a voice alarm “
RECORDING STARTED
…
”.
2. When the camera’s battery is depleting or low, the camera will emit a voice alarm “
LOW
BATTERY
…
”
.
3. When there is only 200mb of storage remaining, the camera will emit a voice alarm “
CARD
FULL, CARD FULL
…
”
.
4. Upon changing the settings on the camera and hitting ‘apply’ these changed settings via a
computer connection (
See Change Settings Instructions
) will be saved with a voice alarm
stating “
UPDATE SETTINGS
…
”
, after disconnection of the camera from the computer.
Charging
Place the camera into the charging dock so that the Lens side of the camera is facing the LED on the
front of the dock. Plug the USB cord into the back of the dock and attach the other side of the USB
into an outlet, computer, or plug the USB into a charging dock and attach the dock into a power
outlet. You may also use a car charger to charge your camera.
Page 4
