13
Functions of each part
Forward facing and rear facing/interior view camera
The camera must be horizontal and vertical. When the lens of the
camera is obstructed or is dirty, clear images may not be captured.
Periodic cleaning is required. To clean the lens, use a soft camera lens
cloth to prevent damage.
Emergency record button (Video image removal protection)
In order to record diver detected scenes of interest, press the emergency
record (E) button to record. This data records 1 minute before and 1
minute after. (User may set pre-event time 1 minute, 2 minutes or 3
minutes). Stored event recording data in SD card will not be erased
unless user cancels (A remote button is also provided for this function for
covert recording) The recording time is determined in prerecording time.
SD card slot
Before inserting / removing the SD card, Power must be OFF.
The LED Display must be off. (BLANK!)
Manual Cancellation of the Emergency Manual Record if enabled in software
Press the “M” button for about 3 seconds until you hear a chime from the
speaker. This is used in the rare case if the SD card is full and was not
replaced. This function is typically not enabled so to secure all recordings.
If enabled in system setup, all the previous events and the overwritten
record protection is disabled when this button was activated, allowing
the system to overwrite alarm data. (rarely used)
Volume control
Adjust the audio volume level for driver’s convenience. When you turn it
left (<<), it increases the volume while a right (>>) turn decreases the
volume.
Power connection port
Connect one end of the cigarette lighter plug cable into the matching
connector of the power port of the unit. Plug the other end of this cable
to the cigarette lighter plug of the vehicle. {Power may be hard wired
(permanently wired) into the ACC (accessory) switched power of the
vehicle for a more secure installation. REFER THIS TO TRAINED PERSONEL
ONLY.} Do not lose the supplied power cord or use other cables. If
damaged or lost, contact your Reseller for a replacement.
LED Display window
System status is displayed on this multi-segment display.
Used for system status and system diagnostics.
