User's Guide HDSP System Digiface
© RME
39
21.3 Supported Sample Rates
RME's Mac OS X driver supports all sampling frequencies provided by the hardware. Besides
96 kHz
this also includes
32 kHz
and
64 kHz
.
But not every software will support all the hardware's sample rates. For example Spark does
not display 32 kHz and 64 kHz. The hardware's capabilities can easily be verified in the
Audio
MIDI Setup
. Select
Audio devices
under
Properties of:
and choose the Hammerfall DSP. A
click on
Format
will list the supported sample frequencies.
If the unit is in clock mode
Master
, selecting a sample rate will immediately set the device to
this frequency, which can be verified in the HDSP's settings dialog (System Clock).
Format
thus allows you to activate any sampling frequency quickly and easily.
21.4 Repairing Disk Permissions
Repairing permission can solve problems with the installation process - plus many others. To
do this, launch
Disk Utility
located in
Utilities
. Select your system drive in the drive/volume list
to the left. The
First Aid
tab to the right now allows you to check and repair disk permissions.
21.5 PCI card and PCI slot compatibility
Unfortunately not every RME card will work in every PCI slot of an Apple computer. To our
knowledge, the current Hammerfall DSP systems can be used in any PCI slot of all G4 and G5
models. In case additional PCI cards of any manufacturer are used, it might happen that the
RME card is no longer found by the system. Swapping cards between slots can be helpful in
this case.
21.6 Various Information
The driver requires 10.2.8 or higher. Older versions of OS X are not and will not be supported.
Via
>System Preferences/ Audio-MIDI Setup<
the hardware can be configured for the system
wide usage. Programs that don't support card or channel selection will use the device selected
as
Standard-Input
and
Standard-Output
. (Soundstudio, Mplayer, Amplitube etc.).
In the lower part of the window, the audio hardware's capabilities are shown and can be
changed in some cases. On the record side no changes are possible. Programs that don't sup-
port channel selection will always use channels 1/2, the first stereo pair. To access other inputs
use the following workaround with TotalMix: route the desired input signal to output channels
1/2. Hold the Ctrl key down and click on the labels A1_1 and A1_2 in the third row. Their labels
turn red, the internal loop mode is active. Result: the desired input signal is now available at
input channel 1/2, without further delay/latency.
Since OS X 10.3 playback can be configured freely and to any of the available playback chan-
nels. This is done via
Speaker Setup
. Even multichannel playback (Surround, DVD Player)
can be set up easily.
Summary of Contents for Hammerfall Digiface
