RME Audio ADI-2 DAC, User Manual

Page: 51 / 68

User’s Guide ADI-2 DAC © RME 51
!
IEM
As Phones, but:
x
Output level at 0 dBFS: -3 dBu, 0.55 V
x
Signal to Noise ratio (SNR) @ -3 dBu: 115 dB RMS unweighted, 118 dBA
x
Max power, 8 Ohm, 0.001% THD: 40 mW per channel
30.3 Digital
x
Clocks: Internal, SPDIF In
x
Jitter suppression of external clocks: > 50 dB (2.4 kHz)
x
Effective clock jitter influence on DA conversion: near zero
x
PLL ensures zero dropout, even at more than 100 ns jitter
x
Additional Digital Bitclock PLL for trouble-free varispeed ADAT operation
x
Supported sample rates for external clocks: 28 kHz up to 200 kHz
x
Internally supported sample rates: 44.1 kHz up to 768 kHz
30.4 General
x
Included power supply: external switching PSU, 100 - 240 V AC, 2 A, 24 Watts
x
Standby power consumption: 120 mW (10 mA)
x
Idle power consumption: 7 Watts, Max. power consumption: 18 Watts
x
Idle current at 12 V: 570 mA (6.8 Watts)
x
Dimensions (WxHxD): 215 x 52 x 150 mm (8.5" x 2.05" x 5.9")
x
Weight: 1.0 kg ( 2.2 lbs)
x
Temperature range: +5° up to +50° Celsius (41° F up to 122°F)
x
Relative humidity: < 75%, non condensing
30.5 Connector Pinouts
XLR Connectors
The XLR sockets of the analog outputs are wired according to international standards:
1 = GND (Shield), 2 = + (hot), 3 = - (cold).
The XLR outputs do not operate servo-balanced! When connecting unbalanced
equipment, make sure pin 3 of the XLR output is not connected. A connection to ground
might cause higher THD (distortion) and power consumption!
TRS Phones jack
The analog output channels feed
two
Phones outputs via two
independent driver circuits.
In case these outputs should oper-
ate as Line outputs, an adapter TRS
plug to RCA phono plugs, or TRS
plug to TS plugs is required.
The pin assignment follows interna-
tional standards. The left channel is
connected to the tip, the right chan-
nel to the ring of the TRS jack/plug.