Copyright © 2013 Ready Made RC, LLC
8
26. Insert control rod into stoppers
for rudder and elevator. Secure with
screws and blue thread locker while
being sure that control surface is
flush with stabilizers.
27. Balance prop and slide over prop
adapter. Be sure to align the hex
section at the base of adapter with
that of the prop as shown as you
tighten down.
28. Wing wheels
(optional)
– Dry fit
into wings. Gear should be swept
back from front. Separate wire
landing gear from housing by
pressing tabs together. Glue hosing
into wing with epoxy.
-
Important: Only apply glue
where housing touches wing.
Otherwise, you will not be
able to insert tabs/wire.
29. After allowing epoxy to set,
inset wire back into housing and
secure by pressing tabs fully into
place.
