Copyright © 2013 Ready Made RC, LLC
6
20. Insert rudder into fuselage cavity
and on top of horizontal stabilizer. T
bracket should fit directly into
stabilizer. Check for proper
alignment through the bottom again
as well. Secure with 2 Phillips
machines screws.
-
A small amount of trimming
may be required if the front
of the rudder does not slide
in easily.
21. Attach control rod stopper to
rudder and elevator to control horns.
Note that for the rudder, the stopper
should be on top, and on the right
side for the elevator. Do not clamp
down onto horn with nut.
-
Use blue thread locker on
outside of nut to avoid
contact with the horn.
22. Pull servo wires through servo
plate and screw into place. Elevator
servo should be facing the back of
the fuselage. Rudder servo should be
facing the front.
-
Some extra trimming of the
servo mounting plate may be
required with different
brands of servos.
