Copyright © 2013 Ready Made RC, LLC
4
10. Locate tail bracket “T” plate
shown in picture. Dry fit into rudder
and then glue into place. Bracket
should be flush with rudder surface.
11.
Note: If your setup requires
wiring through the tail, now is the
time to do so. I have added a 36”
Dragon Link antenna. Room was
made by cutting small notches in the
ribs.
-
Pull apart halves of fuselage.
Note where points of contact
are. Mix epoxy and work
your way around one half of
fuselage. Carefully join
halves and gently secure
with clamps or other
preferred method.
Continually inspect for
separated sections and press
them together as glue sets.
12. Insert ESC motor wires through
wing channel and push through
access hole.
-
Partially insert motor
housing onto fuselage and
pull wires through. Check
that motor housing has 4
lock nuts installed in back.
13. Dry fit housing to be sure it can
seat fully. Apply CA to housing
contact points while being careful to
avoid wires. Be sure that housing is
completely set and forward while
holding in place.
