52
7-10. Replacing a Remote Sensor Cable
NOTE
•
The wire colors in the extender cable may vary depending on the type of cable used. The Type A
cable has red/green/white/black wires, and the Type B cable has white/yellow/white/blue wires.
The pictures in this section show the Type A cable.
2
Remove the sensor cover of the
old cable’s remote sensor
housing.
Push the tabs on both sides of the
sensor cover with your fingers to
release the sensor cover latch.
3
Remove the cable plug from the
cable socket on the sensor board.
Press the tab on the plug to release it
and pull it away from the socket.
4
Remove the sensor from the
sensor board and set it aside.
5
To remove the sensor board,
insert a flathead screwdriver into
the back of the extender housing
as shown in the figure to the
right.
Push on the retaining tab.
The sensor board should fall out
when the retaining tab is pushed.
1
Turn off or disconnect power to
the RI-600.
