IMS01P04-E4
7
5. MOUNTING
5.1 Mounting Cautions
(1) This instrument is intended to be used under the following
environmental conditions.
(IEC61010-1)
[OVERVOLTAGE CATEGORY II, POLLUTION DEGREE 2]
(2) Use this instrument within the following environment conditions.
•
Allowable ambient temperature:
−
10 to
+
50
°
C
•
Allowable ambient humidity: 5 to 95 % RH
(Absolute humidity: MAX.W.C 29.3 g/m
3
dry air at 101.3 kPa)
•
Installation environment conditions: Indoor use
Altitude up to 2000 m
(3) Avoid the following when selecting the mounting location.
•
Rapid changes in ambient temperature, which may cause
condensation.
•
Corrosive or inflammable gases.
•
Direct vibration or shock to the mainframe.
•
Water, oil, chemicals, vapor or steam splashes.
•
Excessive dust, salt or iron particles.
•
Excessive induction noise, static electricity, magnetic fields or
noise.
•
Direct air flow from an air conditioner.
•
Exposure to direct sunlight.
•
Excessive heat accumulation.
(4) Mounting consideration
•
Install the module 200 mm away from the main power line.
•
Ensure at least 50 mm space on top and bottom of the control
unit for maintenance and environmental reasons.
(5)
This instrument is permanently connected to equipment,
please take the following points.
•
A switch or circuit-breaker shall be included in the building
installation.
•
It shall be in close proximity to the equipment and within easy
reach of the operator.
•
It shall be marked as the disconnecting device for the
equipment.
5.2 Dimensions
(Unit: mm)
110
6.8
40.5
125
78
5
The above figure shows when provided with the event
input/output connector, but the same also when not
provided with the connector.
Depth in connector mounting
Conduct installation in consideration of the sizes of the
connector and cable when connector-connected.
110
[Usage example of SRVP-01]
(Unit: mm)
Approx. 50
Connector (plug):
SRVP-01
(sold separately)
5.3 DIN rail Mounting
Mounting procedures
1.
Pull down the mounting bracket at the bottom of the module
(A). Attach the hooks on the top of the module to the DIN rail
and push the lower section into place on the DIN rail (B).
(Fig. 1)
2.
Slide the mounting bracket up to secure the module to the
DIN rail. (Fig. 2)
(B) Push
Mounting
bracket
DIN rail
(A) Pull down
Locked
Fig. 1
Fig. 2
End Plate mounting
Hold tight both ends of the modules jointed together with the end
plates and then fix the end plates with screws. Even if only one
V-TIO-E/F module is used, also hold tight both ends of the
module with the end plates.
End Plate
V-TIO-E/F module
End Plate
Joint connector cover
*
*
For the conservation of the contact of connector, install a joint
connector cover in module of both ends.
Removing procedures
Pull down a mounting bracket with a blade screwdriver (A). Lift
the module from bottom, and take it off (B).
(A) Pull down
(B) Lift and take off
To prevent electric shock or instrument failure,
always turn off the power before mounting or
removing the instrument.
!
WARNING
