4
Transport and storage
NOTICE!
It is prohibited to commission damaged linear
units!
Immediately check the delivery upon receipt to ensure that it is
complete and free from transport damage. Report the extent of the
damage to the person responsible and to RK Rose+Krieger GmbH
immediately.
WARNING!
Risk of injury due to improper transport!
Loads can swing out, topple over and fall down
during lifting operations. This can cause severe
injuries.
– Never step under or into the pivoting range of
suspended loads.
– Only use approved lifting gear and load suspen-
sion devices with a sufficient load-bearing
capacity.
– Observe the linear unit’s centre of gravity.
– Wear an industrial protection helmet.
Observe the following during transport:
n
Ensure that, when a crane, lifting cart or even persons are lifting
the linear unit, it is not picked up by its end elements.
n
Move the linear unit’s guide carriage into its end position and
secure it before transport.
n
Avoid impact on the linear unit’s shaft ends during transport.
Store the linear units under the following conditions:
n
Only place it on a load-bearing substrate.
Ensure that the entire guide profile or a corresponding number
of support points along the guide profile are placed flush on the
substrate.
n
Avoid contact with solvent-based varnishes.
n
Do not expose to air containing oil.
n
Storage temperature: 0
-
60°C
n
Humidity: Temperatures below the dew point are not permitted.
Deviating environmental conditions must be
approved by RK Rose+Krieger GmbH.
Transport inspection
Transport
Storage
Transport and storage
14.10.2021
Linear unit RK MonoLine R/RK MonoLine Z
94