Product Manual | Lynx™ Embedded Sensors LES‑B‑127‑50/125/500/2000
17
3.
Transfer Pin Shaft and Head Pocket
Machine a pocket for the transfer pin shaft
in the ejector plate with an H7/g6 fit for
0.5” (12 mm [
1
at right]) MIN.
Machine a pocket for the transfer pin head
in the ejector plate that is equal to the
transfer pin head DIA plus 0.02” (0,5 mm [
2
at right]) MIN per side. Allow 0.01” (0,3
mm [
3
at right]) MIN clearance below pin
head. Chamfer the transfer pin head pocket
at 45° (
4
at right).
4.
Ejector Pin Head Pocket
Machine a pocket for the ejector pin head
in the ejector retainer plate that is equal
to the ejector pin head DIA plus 0.02”
(0,5 mm [
5
at right]) MIN per side.
Allow clearance above the ejector pin
head. If the part thickness is < 0.05”
(1,5 mm), the clearance should equal 20%
of the part thickness. If the part thickness
is > 0.05” (1,5 mm), the clearance should
equal 0.01” (0,3 mm [
6 i
at right]).
NOTES
L
Ejector pin head clearance not to
exceed 20% (1/5th) of part thickness
at point of pin/part convergence.
Chamfer the lead‑in edge 45° (
7
at right).
CAUTION
a
Transfer pin applications require
guided ejection; failure to comply
may result in damage to or
destruction of components.
1
H7/g6 for 0.5” (12 mm) MIN
2
0.02” (0,5 mm) MIN per side
3
0.01” (0,3 mm) MIN
4
45° Chamfer, refer to TABLE J on page 15
5
0.02” (0,5 mm) MIN per side
6
20% part thickness if < 0.05” (1,5 mm), 0.01” (0,3 mm) if part thickness > 0.05” (1,5 mm)
i
7
45° Chamfer, refer to TABLE J on page 15
INSTALLATION SPECIFICATIONS (
continued
)
2
1
3
4
5
6
7
CLAMP PLATE (HEAD‑TO‑HEAD) INSTALLATION
