ULB-362B Underwater Locator Beacon
6
User’s Manual
January 2018
Installation Procedures for ULB-362B and
ULB362-02 Mounting Bracket
Carefully unpack the beacon and inspect it for shipping damage. If any
damage is evident, it should be reported to the freight carrier and to RJE
International, Inc. If ordered, the mounting bracket kit includes an aluminum-
mounting bracket, an aluminum end plate, three drilled (for lockwire) socket
head cap screws, and three lock washers.
NOTE:
Before installing the mounting bracket, be sure that it will be
possible to install and remove the beacon once the bracket is
installed.
To mount the beacon, perform the following steps:
1. Ensure the beacon is mounted in the vehicle so that it has a clear path to send
the acoustic signal. Avoid mounted it behind other equipment.
2. Mount the beacon with the water switch down to prevent accidental activation.
3. Refer to the mounting bracket hole pattern shown in Figure 3-1 and drill four
0.19in (0.5cm) diameter holes.
4. Secure the mounting bracket with four 10-32 stainless steel screws and
associated hardware (not supplied) as shown in Figure 3-2.
5. Slide the beacon into the bracket as shown in Figure 3-3. Rotate the beacon
until the battery date is visible and secure it in place with the end plate and the
three drilled socket head cap screws.
6. Lockwire the drilled screws and clean the water activation switch (refer to section
4 Beacon Cleaning).
Figure 3-1 Mounting Bracket Hole Pattern
