RivieraPool Penta P, Instructions For Installation And Use Manual

Page: 6 / 16

6
2.8.4 Cascade
2.8.5 Blower
2.8.6 Lighting
Start up and use
warm
Mode
cool
Blower
Jet 1 Jet 2
Light
All models except the Penta P are equipped with a cascade.
The water cascade is fed by the filter pump and only operates when the filter
pump runs. The filtration time is programmed from 08:00hrs until 22:00hrs
and 18:00hrs 22:00hrs.
The cascade can be controlled by opening and closing the valve on the side.
When the pool is covered, the control valve should be closed. Otherwise, water
will be pushed under the cover and water could run over the border of the pool.
Note: the cascade can’t be closed completely. This is to avoid standing water
in the pipes. The performance of the cascade diminishes as the filter cartridge
becomes dirtier. This means that, when the water pressure becomes too little,
the cartridge should be cleaned or replaced.
By pressing this button the air blower will be switched on and off. The
blower switches itself off automatically after 15 minutes. note: At low
outside temperatures cold air is blown into the whirlpool. The water
temperature might drop and the heater might not be able to compensate
this difference immediately. Even with normal outside temperatures the
air blown into the pool could feel cold to the skin when the bather sits or
lays directly on a jet nozzle. This button always exists even if the pool is not
equipped with a blower.
The lights are turned on by pressing this button. The lights are turned off
automatically after 4 hours. When an LED light is present, the colours and
the speed of the light change when the button „Light“ is being pressed.
warm
Mode cool
Blower
Jet 1 Jet 2
Light
Switching valve
(position filter)
Cascade
on/off