10
Care and maintenance
3.3
Cleaning and Maintenance
of the wooden surfaces
3.4
Winter care
3.4.1 The pool is set on “sleep
mode“
3.4.2 If the pool stays empty
during winter
ATTENTION! Please do not use any solvent-containing cleaners as they might
affect the acrylic surface.
Dull surfaces can be polished up so that they shine even after years. A
special surface polish called „Poolfinish“ is available for just this purpose.
This is applied with a soft cotton cloth and polished with gentle circular
movements. Minor scratches can also be removed this way.
Wood is a natural product and depending on weathering its appearance
will change over the course of time. Teak only acquires its unique silvery
sheen after a certain weathering. A degree of „movement“ with wood is
unavoidable. We recommend taking precautions to keep weathering to a
minimum.
Wooden surfaces should be kept as dry as possible. They should be cleaned
with lukewarm water and a leather cloth.
if required, teak surfaces can be treated with a special varnish. This is
painted onto the wood and gives the surface a new sheen. Before treating
teak in this way, the surface must be rubbed down using fine sandpaper. A
tin of teak varnish is provided with every whirlpool.
if the isola spa is not used during winter the following has to be observed:
The pool is set on “sleep mode“ and remains filled with water. Adjust the
temperature to 36 degrees C.
Clean the filter cartridge.
The water will now be disinfected and filtered during winter. The temperature
might fall to 11 degrees C but the frost proctection is activated.
Attention: in the event of an electricity cut-off the “ sleep mode” has to be
reset . if not done the pool might get damaged through frost.
Please check the water level in regular intervals.
To restart the operations set into “ standard mode”.The water will now be
heated to the set value 36 degrees C.
Please check the water level.
Please clean the filter cartridge.
Switch off the electricity supply. Open all the valves and drain the pool and
the piping system. Open the drainage screws of the massage pumps. Take the
cartridge out of the filter, clean it and store it in a dry place.
Place the hard top cover on the pool; if necessary remove snow.
To restart the operations close all the valves again, replace the drainage screws
into the massage pumps, refill the pool up to the mark on the skimmer and
switch on the electricity. (please see 2.2 “switching the power supply on/off”)
Summary of Contents for Penta P
Page 14: ...14 Notes...
Page 15: ...15 Notes...
