Operator's Manual
LOCKDOWN 21 2-MAN Ladder Stand
Check for parts online at
www.HuntRiversEdge.com
or call 800-450-EDGE (3343) M-F 8-5
12
SEAT PAD (21)
25. Attach removable seat pad (21) to the metal seat frame by
sliding seat frame into pocket. Wrap buckle straps around
seat frame and secure together. Pull straps tight so seat is not
loose.
LONG CRISS CROSS RATCHET STRAPS (46)
23. Attach the two long straps of the criss cross ratchet straps
(46) to the rear of the J-tubes near the lower tree blade.
a. Wrap sewn loop of each strap around the J-tubes on each
side of the platform and feed the loose end through the
sewn loop. SEE FIGURES 12A & 12B.
b. Pull tight, forming a cinch knot. This permanently attaches
the long straps to the platform. SEE FIGURES 12B & 12C.
NOTE: The ratchet portion of the long straps will be used
later during the Setup and Use instructions.
STABILIZER BAR RATCHET STRAP (47)
24. Attach the straps of the stabilizer bar ratchet assembly (47) to
the stabilizer bar bark biting plate.
a. Feed the sewn loop of the long strap through either side
slot in the bark biting plate and then feed the loose end
through the sewn loop. SEE FIGURES 13A & 13B.
b. Pull tight, forming a cinch knot. This permanently attaches
the long strap to the stabilizer bar. SEE FIGURES 13B & 13C.
c. Feed the sewn loop of the ratchet buckle strap through the
opposite side slot in the bark biting plate and then feed the
ratchet buckle through the sewn loop.
d. Pull tight, forming a cinch knot. This permanently attaches
the ratchet buckle strap to the stabilizer bar. SEE FIGURE 13C.
LARGE RATCHET STRAPS (45)
The large ratchet straps (45) that secure the platform and tree
blades to the tree will be used later during the Setup and Use
instructions, after uprighting the stand.
NOTE: Make sure to bring ratchet straps up with you in a
pocket. Never carry in your hands!
FIGURE 12A
FIGURE 12B
FIGURE 12C
FIGURE 13A
FIGURE 13B
FIGURE 13C
BACKREST PAD (22)
26. Attach removable backrest pad (22) to the TearTuff
™
mesh
backrest with hook and loop attachment strips on the top
and bottom of the back of mesh and the left and right sides
of the front of the mesh.
