Check for parts online at
www.HuntRiversEdge.com
or call 800-450-EDGE (3343) M-F 8-5
9
Operator's Manual
LOCKDOWN 21 2-MAN Ladder Stand
10. Slide top ladder section (13) into J-tubes (1) and secure with
two silent knobs (40). These silent knob assemblies consist of
a simple threaded knob with carriage bolt. Thread the knob
onto carriage bolt, only about 2 turns. Insert the head of
carriage bolt into the large end of the key hole type opening
in ladder pocket and slide the square “block” portion of
carriage bolt head down into the slot. Doing this will capture
the square “block” portion of carriage bolt and hold it in
place. Tighten the knob by hand until tight which will draw
the two ladder sections together and eliminate any slop
between the ladder sections. SEE FIGURES 7 AND 8.
11. Insert bent end of one platform brace (12) into the lower
end of one ladder hand rail (11). Attach connection point to
the outside edge of the top ladder section (13) using one
5/16-18 x 2-1/2in bolt (30) and 5/16in locknut (35). Make sure
bolt passes through ladder hand rail, platform brace and top
ladder section. SEE FIGURE 7.
12. Repeat previous step for opposite platform brace (12) and
ladder hand rail (11). SEE FIGURE 7.
13. Attach the free end of both ladder hand rails (11) to the
J-tubes (1) just in front of the front platform using two 5/16-
18 x 2-1/2in bolts (30) and 5/16in locknuts (35).
SEE FIGURE 7.
14. Attach the free end of both platform braces (12) to the J-tubes
(1) below the rear platform using two 5/16 x 18 x 2-1/4in bolts
(29) and 5/16in locknuts (35). SEE FIGURE 7.
40
35
30
13
29
30
35
12
11
1
1
5/16 x 18 x 2-1/4in Bolt - Qty 2
29
5/16-18 x 2-1/2in Bolt - Qty 4
30
FIGURE
7
5/16in
Nut
Qty 6
35
FIGURE 8
40
