21
21
FITTING THE DOWNPIPE
• Silicone the lip of the dropper that will be in contact with the spouting. Place it in the hole. Make sure it is straight. Add extra silicone as required for a
watertight seal. Allow the silicone to dry.
• Measure and cut the downpipe to the right length, push it up tight and secure tightly by using one rivet through into the dropper and riveting the two
brackets to rear wall cladding.
• Position the downpipe cover flashing over downpipe and rivet to wall cladding using 6 rivets.
FITTING THE DOWNPIPE
21
FITTING THE FRONT TOP PLATE FLASHING
• The Front Top Plate Flashing sits on the top plate and comes down the
front of the shed over the top of the front wall cladding. The folded edge of
the flashing is on the front part of the flashing.
• Place the flashing on the top plate with the folded edge facing down.
Ensure that it is flush with the timber at each end and nail it into the top
plate place using 5 x 30mm clouts.
Folded
Edge
