POST ASSEMBLY
The posts can be assembled as necessary to
provide support for the straps in one or multiple
directions. Use the ½" x 6-1/2" bolts and lock nuts
provided to bolt the posts together as necessary for
your application. See Figures 3-6 for typical post
configurations. The holes in the post are offset to
allow the hardware to be through bolted. Be sure to
align the posts so the sides being bolted together
have holes at the same height. Do not fully tighten
the hardware until it is completely assembled.
Notice that the same bolts used to hold the posts
together may be used to hold on the tensioner
assembly brackets or the storage system brackets.
TENSIONER BRACKET
INSTALLATION
Use the ½" x 6.5" bolts and lock nuts provided to
fasten the U-shaped tensioner bracket to the post.
Note that you may be using the same hardware that
is being used to attach the reinforcement post cross
members. The holes on the tensioner bracket are
offset to allow the strap to be at the same height off
of the floor on different sides of the post. Position
the bracket in the proper direction before fastening
to the post.
INSTALLATION INSTRUCTIONS
6
P
UB
. N
O
. GUARDRITE STRAP REV 3.1 - © JUNE 2013
GUARDRITE
®
STRAP SYSTEM BARRIER
Single Post with Tensioner Bracket
Figure 3
Offset Hole Pattern for Bracket Alignment
Figure 5
Double Post with Tensioner Bracket
and Storage System
Figure 4
Triple Post with Tensioner Bracket and
Storage System
Figure 6
