Page
22
User Manual
GARDTEC
872
Part Setting The System
(using Master & Main type codes)
1)
With the display showing
T M
Enter a Master or Main type code
2)
The display will show
R D
(flashing). Press 1, 2 or 3 (for Part 1, 2 or 3) the
display will show the
D
and:-
The two bottom bars if Part 1 has been selected
(
D %
)
The top and bottom bars if Part 2 has been selected
(
D &
)
The bottom bar only if Part 3 has been selected
(
D ]
)
Note:
If a Global code (Master or Main) has been used all areas that are being
set would be Part Set.
Note:
If an Area Main code has been used only the Part Set associated with
that area would be Part Set.
3)
The exit tone may or may not be heard dependant on the system settings.
4)
Exit the premises or retire to an unprotected part of the system. At the end
of the exit time either the exit tone will stop or a single beep will be emitted
(dependant on system settings).
Part Setting System (using Area 1, 2 or 3 codes)
1)
With the display showing ' Un ' Enter an Area code (1, 2,3, 4, 5, 6, 7).
2)
The exit tone will sound and the display will show
D $
3)
Press NO, then 1, 2 or 3 (for Part 1, 2 or 3). The bars on the display will
change to:-
The two bottom bars if Part 1 has been selected
(
D %
)
The top and bottom bars if Part 2 has been selected
(
D &
)
The bottom bar only if Part 3 has been selected
(
D ]
)
4)
The exit tone may or may not be heard dependant on the system settings.
5)
Exit the premises or retire to an unprotected part of the system. At the end
of the exit time either the exit tone will stop or a single beep will be emitted
(dependant on system settings).
PR5407.qxd 05/11/2003 15:12 Page 22
