Rinstrum D32 series, Manual

Page: 8 / 48

Remote Display Installation Manual
– Software Version 4.x
Page 8 D300-602-202
4. Installation
4.1. General Setup Information
The following steps are required to set up the remote
display.
•
Inspect instrument to ensure good condition.
•
Ensure mounting options and connectors are available.
•
Use connection diagram to wire up power and serial
cables as required.
•
Then D32x remote display can be panel mounted. Use
the "Panel Drilling Template" provided for hole
locations. The panel mounting screws are also used to
attach desk/wall brackets or the stainless steel rear
housing accessories.
•
Connect the serial and power cables to the instrument.
If using an RS-232 to RS-485 converter, connect the
converter between the serial cable and the remote
display
serial port connector.
•
Set the transmitting device to 9600 or 19200 baud and
select the preferred output format for that instrument.
4.2. Panel Mounting (D32x Only)
The simplest way to mount the instrument is to use the drill
template supplied. The template indicates positions for the
drill holes for the two 4mm mounting screws through the
panel. Also displayed on the template is the position of the
rectangular hole that should be cut to allow for the
connection of cables. The drill template supplied with the
indicator allows for front or rear machining of the panel.