Rinnai Australia
9
Operation Manual
SAFETY
DO NOT
restrict the warm air discharge by placing articles in front of the heater. This appliance must not be used
for any purpose other than heating.
DO NOT
allow anyone to post articles through the louvres or let flammable and combustible materials to come into
contact with the heater.
DO NOT
place articles on or against this appliance, on the heaters top panel or obstruct the auto overheat
discharge vent.
DO NOT
spray aerosols in the vicinity of this appliance whilst the heater is operating. Most aerosols contain
flammable gas, which can be a fire hazard if used near the heater when it is in use.
DO NOT
store flammable materials near this appliance.
DO NOT
modify this appliance.
Young children should be supervised at all times. Hand or body contact with the warm air discharge louvres and
glass must be avoided.
DO NOT
allow young children or the infirm to sleep directly in front of the heater while in operation.
DO NOT
allow anyone to sit on or lean against the appliance.
DO NOT
unplug the heater while it is in operation or while the fans are still cycling. Unplugging the heater will cause
any timer operation to stop. Timer programs are stored in the memory of the remote control.
A dedicated 230~240V 50Hz 10 Amp power point must be used with this appliance.
DO NOT
use power boards or
double adaptors to operate this appliance. The appliance
MUST NOT BE
located below a power Point.
Heat emanating from the front of this appliance may over time affect the appearance of some materials used for
flooring such as carpet, vinyl, cork or timber. This effect may be amplified if the air in the room contains cooking
vapours or cigarette smoke. To avoid this possibility, it is recommended that a mat be placed in front of the
appliance, extending at least 750 mm in front of it.
