Rinnai Australia
28
Installation Manual
HEATER INSTALLATION
6.
COMMISSIONING
7.
INSTALLING THE OUTER FASCIA PANEL
8.
INSTALLING THE DRESS GUARD & INNER FASCIA PANEL
Extended Flue
The gas pressures of the appliance are factory pre set for ‘extended flue’ installations (page 22 Options
,
,
and
) and will normally not require adjustment and you may proceed to step 7.
Direct Flue
If the appliance is to be used with a ‘direct’ flue system
(page 22 Option
), then gas pressures will need to be
adjusted in accordance with the commissioning
instruction sheet
located in a plastic pouch inside the
appliance at the bottom right.
When commissioning is complete check for full and
correct operation of the appliance, and return the
commissioning instruction sheet to its plastic pouch,
proceed to step 7.
1.
Remove
DO NOT DISCARD
the two fascia retaining screws
shipped installed in the lower fascia mounting
brackets
of the heater engine.
2.
Position the fascia close to the heater engine and connect the RJ45 plug into the socket located on the inside
top left of the fascia
, (this connects the push button control panel via a communications cable to the heater
engine's control box).
3.
Mount the outer fascia
to the engine by hooking the inside fold of the top of the outer fascia
to the top
lip of the engine body
, then rotate the bottom of the outer fascia
in towards the engine body. Secure
the fascia to the heater engine with two retaining screws
.
1.
Using slots
hang the mesh dress guard
onto the tabs
of the of combustion chamber glass frame.
2.
Mount the inner fascia
to the engine by hooking the tabs of the inside top of the inner fascia
to the top
lip of the combustion chamber frame
.
3.
Rotate the bottom of the inner fascia
in towards the engine body allowing the magnets
to secure both
the inner fascia and the dress guard to the heater engine.
II
III
IV
V
I
L
L
M
N
c
b
P
M/N
a
M
O
O
O
P
a
b
c
M
a
Q
b
R
c
d
f
c
d
R
e
b
a
Q
R
Q
P
e
f
