3
HOW TO USE
•
Preparation and Verifi cation Before Use
Preparation
•
Make sure that the burner control knob is at the “OFF” position and then fully turn on the gas
valve.
•
Fill the water tray with water until the water level indication.
•
How To Use
•
For RGA-404B, a single ignition (or extinguishing)
operation ignites two burners (or turn off).
•
For RGA-404C, a single ignition (or extinguishing)
operation ignites one burner (or turn off).
•
Wipe the main unit with a clean cloth.
•
Wash the grate, heat shield plate, rotisserie
sticks and water tray using neutral detergent
and then wipe them with a clean cloth.
- 8 -
Verifi cation
•
No flammable object such as paper, plastic, oil and spray can is placed near the appliance.
•
The rubber hose is not cracked, excessively bent or in contact with the griller. (For a rubber hose
connection)
•
When an air conditioner with fan is used, do not allow the wind from the air conditioner to blow
directly onto this appliance.
When using this appliance for the first time
When the burners are ignited for the first time,
the ignition may not be smooth due to the air
trapped in the hose. In this case, repeat the
ignition operation few times until the air is
released. If the ignition attempt fails, turn the
burner control knob back to the original position
and then make another ignition attempt. Ignition
may fail if the knob is turned too fast.
Attention
•
When turning on the gas valve,
be extra careful not to turn on
a gas valve not connected to
any appliance or control the
gas valve connected to another
appliance.
•
Do not bring your face too near
when checking an ignition.
•
The burner control
knob slightly returns
up to “ON” position.
(OFF)
(ON)
Ignition
•
Press the burner control knob and slowly
turn counterclockwise until a click sound
can be heard.
•
A click sounds and the pilot burner is ignited.
Keep the knob pushed in and turned for a
few seconds until the main burner is ignited.
•
Release your hand from the burner control
knob only after making sure that the main
burner has been ignited.
CAUTION
•
If the griller is used without filling the water tray
with water, the oil and fat deposited on the water
tray may catch fire. Be sure to fill the water tray
with water to approximately half level before use.
•
During use, make sure from time to time that the
water tray is filled with water without a lot of oil and
fat deposited. If the oil or fat deposited on the tray
starts splashing, be sure to replace water on the
tray to remove oil and fat. If the water tray is used
without replacing water, the splashed oil and fat
may catch fire. Caution should be exercised during
water replacement as the water tray may be very
hot.
(OFF)
(ON)