4
TROUBLESHOOTING
•
Fault/Error Identifi cation and Remedy
WARNING
If you notice something abnormal while in use, immediately stop
using this product and shut off the gas valve.
Action to be taken
If the problem still persists even after you have checked the above items, stop using the griller
immediately and contact your dealer or any Rinnai offi ce.
- 12 -
Things to check
(Cause)
The fl
ame is not ignited.
It is hard to ignite
.
The b
u
rner does not tur
n
red when heated.
It is hard to ignite (from pilot b
u
rner to main b
u
rner)
Explosion-lik
e ignition
Flame b
u
rns with abnor
mal
noise
The fl
ame goes off while
using.
It is easy to distinguish.
In a case like this
(Symptom)
Forgot to turn on the gas valve
or the gas valve is not
suffi ciently turned on.
Air is trapped inside the gas
pipe
Gas pressure is
not appropriate
High
Not fully connected to
the fuse cock
Deterioration of rubber hose
due to wear and tear
Dirt on the electrode of ignition
system
Clogged fl ame hole or air hole
Improper installation of glass
Improper ignition operation
Lead wire connection problem
for ignition system
Failure of ignition system
Gas type on the nameplate and
gas type used are not matched
Check the position of the burner
control knob and then fully turn on
the gas valve.
Repeat ignition operation with care
until gas is properly supplied.
Request for inspection if this is also
observed on other appliances.
Straighten the bent hose in case of
rubber hose connection.
Flame is y
ello
w
Flame is not stab
le
Fully connect the rubber hose to the
fuse cock in case of rubber hose
connection
Replace the rubber hose or cut off
the hose tip in case of rubber hose
connection.
Wipe off the dirt. If problem persists,
request for inspection.
Remove the clogging object.
If problem persists, request for
inspection.
Install the glass properly.
Refer to “How to Use (Ignition)”
Request for inspection.
Request for inspection, repair or
parts repair
Request for inspection or repair
Low
Bent or squashed rubber hose