Rinnai Neo RIB2312L, Installation Manual

Page: 5 / 36

Neo RIB2312 installation guide: 12148-A 01-17 | 5
Neo Specification
Natural draft burning log effect inbuilt gas fire
with glass front and convection fan. Different
frame options available.
Specification summary
Input = 14-30 MJ/h*
Output = 2.98-6.94 kW*
Efficiency = 80%
Heating area = 69-107 m 2 **
Gas type = NG or ULPG
* Will vary according to gas type and flue configuration
** Will vary depending on geographical location in NZ
Suitability
- Inbuilt masonry
- Inbuilt mock chimney
- Freestanding
The Neo is not suitable for areas where painting
is taking place, or in places such as hairdressing
salons, where there may be fluff and dust, and
where aerosols are used. The inbuilt Neo gas
fireplace models are not designed to be built into
bookcases.
Installation considerations
The Neo draws air for combustion from the room.
Adequate ventilation must be calculated and
provided by the gasfitter as per AS/NZS 5601.1.
Burn media
Driftwood log set comes as standard.
Convection fan
Fan forced 2-speed convection fan (low and high).
Heat is distributed from the top of the appliance.
Data plate
Inside appliance on the front left hand side.
Gas connection
½ “ BSPT (flexi). The gas supply terminates inside
the heater at the lower front right hand side of the
appliance.
Ignition
Continuous spark electronic ignition.
Noise level
37-45 dB(A)
Flue (masonry)
The Neo must be installed with a Rinnai flexiliner
flue (Ø 100 mm).
Flue (mock chimney and freestanding)
Appliance must be installed with a Rinnai flue
system. Inner 100 mm, outer 150 mm.
Power consumption and electrical supply
High = 50 W
Standby = < 3 W
Comes with a 1.5 m power cord and 3-pin plug.
The standard electrical connection is to the rear
left of the appliance, but can pass through the left
or right by removing the knockout tab from the
bottom edge of the front panel.
Safety devices
Overheat switch, electrical fuse, and flame failure
sensing system.
Temperature control
Once the unit is turned on the infra-
red remote* is used to control the
flame height and heat output.
If the remote is not used the Neo
will automatically modulate between
the burner settings to maintain the
default set temperature of 22
°
C.
* Temperature sensor is located in the bottom of the
remote.
Weight
60 kg
23
136 mm
34 mm
depth - 11 mm