13
Adjusting temperature
Select the desired temperature using the hot water temp
or
buttons until the required temperature is displayed
on the digital monitor.
To operate the hot water unit, open any hot water tap: the appliance will control the temperature and turn on the burner
only if it is necessary to heat it. When the burner is on, the ‘In Use’ indicator will light up on the controls connected to
the appliance.
Once the hot water is running, if the set temperature is either too hot or too cold press the hot water temp
or
buttons until the desired temperature is reached.
Temperatures above 50°C should not be selectable from remote controls installed in environments
such as bathrooms or the like: this is to reduce the risk of burns. Contact your installer to correct
the problem
.
Prior to use, to avoid burns, it is recommended to always check the hot water temperature. In
particular, before using hot water for children or infirm persons, an adult should always check the
hot water temperature.
During hot water delivery the set temperature can always be lowered (up to a minimum of 37°C).
For safety reasons, it is not possible to increase its value above 43°C: this is only possible when
the withdrawal of water is stopped (all the taps are closed).
To delete the ‘beep’ emitted by the keys on the control panel, press the
and
buttons at the
same time for at least three seconds. Repeat the procedure to cancel the choice made.
Transferring priority
When more than one command is installed, to change the temperature of
the hot water supplied, it is necessary to transfer the ‘priority’ function to
the desired command. The transfer of the function is not possible when the
‘In Use’ led is on: this means that the appliance is already heating the water
and that some users are active.
The led of the ‘Priority’ key lights up when this function is active on the
control panel. When the led is off, press the ‘Priority’ key once to call up
the function.
Lock function
To prevent tampering and increase the safety level of the product, especially
for children, it is possible to lock the control panel.
To lock the panel it is necessary to press, and keep pressed for about
five seconds, the ‘Priority’ keys and the key to increase the temperature
(up arrow) (Fig.1). To unlock the command it is sufficient to repeat the
procedure of blocking commands.
When the panel is locked, the display shows ‘LOC’ (Fig.2) alternating with
the selected temperature on the display. All connected commands will be
locked and will display the same flashing text.
1.3.3 OPERATION WITH MULTIPLE CONTROL PANELS
The installation of accessories remote commands, allows the temperature to be changed directly from different
environments. The hot water will be supplied to all the users at the temperature set on the control which has the
‘priority function’ activated.
Standard models allow temperature selection and self-diagnosis functions.
Remote controls of another brand are not compatible.
F i g . 1
F i g . 2
NOTE
CAUTION
