Rinnai 16
EHPA Heat Pump OIM
TRANSPORT AND HANDLING
IMPORTANT
When moving the unit, it must be close to vertical at all times.
When using a trolley to move the unit, ensure it is not tilted more than 45° from the vertical.
Non compliance will void warranty and severely affect product performance and operation
45°
Never tilt unit more than 45˚ from vertical
The Rinnai Enviroflo Electric Heat Pump must be transported at an angle no greater that 45º from vertical. As the
compressor unit is located at the top of the electric heat pump, should the heat pump be tilted at a greater angle
than 45º from vertical, the lubrication oil within the compressor can run down into the mufflers. This will leave the
compressor motor without sufficient lubrication and lead to premature failure of the compressor unit.
As a general good practice it is better to keep the compressor upright as much as possible to avoid any risks.
Returning the Rinnai Electric Heat Pump to a vertical position will not allow the oil to properly flow back into the
compressor motor.
Tilting the heatpump beyond 45º from vertical will also place undue strain on compressor motor mounts and
associated piping
POSITIONING THE HEAT PUMP
Arrive at site and conduct a safety audit (Safety audits can also be known as Work Method Statements (WMS) or
Job Site Analysis (JSA).
Park your vehicle as close as allowable to your installation. Unload all materials in a safe manner.
Position all materials in a convenient position near the work area.
The heat pump MUST BE installed outdoors, close to the most frequently used hot water outlet.
The location must consider noise impact on living areas. Avoid positioning near bedrooms or neighbours’ bedrooms.
Although the running noise level is very low it can be expected that the heat pump will run during the night.
Adequate access must be available to the relief valve and anode.
Safely position the new unit on a level surface in accordance with all plumbing and building regulations.
A properly drained overflow tray must be used where property damage could occur from water spillage. (See AS/
NZS3500.4.2 for further details.)
NOTE
Do not drain on to grass or garden beds.
Do not commence a job where the risks cannot be controlled.
INSTALLATION
