Rinnai Australia
18
Energysaver® - Operation & Installation Manual
Setting the Clock
When the appliance is first plugged in or after a power failure, the digital display
with show
--:--
As an example, let’s set the clock to 10:35 am;
Press the SET TIMES
button
once, the Clock indicator
will flash.
Press and hold the “
”
button; the minutes will begin to change first then the time will
change by whole hours.
Release the button when AM 10:00 shows on the Digital Display
. Confirm that you have
selected AM, a small indicator on the left hand side of the Digital Display indicates the AM
setting.
Press and hold the “
”
button again, release the button when AM 10:35 shows. If you go
past AM 10:35, then the “
”
button can be used to change the time settings in reverse.
Press the Timer Set
button five times to lock in and complete setting the time. The Clock
and Timer indicators will go out. A small indicator on the Digital Display
will flash to show
that the Clock is operating.
Setting the ON / OFF Timers
Before programming the Timers you must ensure that the clock has been set to the
correct time.
As an example, let’s program Timer 1 to heat the room by 7:10 am and finish at 9:00 am.
Press the Set Times
button twice. The Digital Display
will show AM 6:00. Timer 1
indicator
will flash.
Press the “
” button until AM 7:00 appears, release the button, then press it again until AM
7:10 appears. (Press the “
”
button if you go past AM 9:00).
Press the Set Times
button three times to lock in the program time. The Digital Display
will show the current time. A small indicator on the Digital Display
will flash to shown that
the display has returned to the clock.
Timer 2 is programmed in the same way, remember to ensure that the Timer 2 indicator
is
flashing when you program in the desired setting.
Set
Room
on off
Filter
Clock
Timer 1
Timer 2
Child Lock Economy Timer 1 Timer 2 Override
Set Times
ON / OFF
AM
PM
ON
Temp
Time
2
4
3
9
13
12
Function Lock
Room
AM
PM
Timer 2
Override
Economy
Set
Temp
Time
Timer 1
Set Times
ON / OFF
Clock
Timer 1
Timer 2
2
1
9
12
3
4
13
on
off
3
2
9
4
3
4
4
2
3
2
3
13
4
2
3
3
13
This procedure is for setting the ON/OFF times for Timers 1 and 2 only. To achieve
the timers refer to details on the following page.
NOTE
SETTING THE CLOCK