Maintain the 5000N
2000447_C
23
Align the Printer
When the Everest printer is installed or replaced, you may need to align it to the
lift arm.
Tools Needed
: Torx T25 driver
Access the Jog Lift Diagnostic Test
1. Power on the
Rimage 5000N
.
2. Allow the system to fully initialize.
Note:
Initialization takes approximately 5 minutes.
3. Be sure that the autoloader is in diagnostic test mode. Follow the instruction
in the
Access Diagnostic Test Mode
section on page 18.
4. Press the
operator button
four times and hold on the last press until the
operator panel displays [STARTING TEST RELEASE BUTTON].
5. Release the
operator button
. The operator panel displays [PLACE
DISC ON PAD TO CHECK PRINTER ALIGNMENT. PRESS BUTTON TO
CONTINUE TEST].
Test the Printer Alignment
1. Place one
disc
on the printer tray in the recessed area.
2. Press the
operator button
.
The operator panel displays [PRESS/RELEASE TO JOG HOLD TO EXIT].
3. Press and release the
operator button
to lower the lift arm until it picks the
disc.
4. Press the
operator button
again to release the disc onto the printer tray.
Summary of Contents for Professional 5100N
