Rimage 2000i Series II, User Manual, Page: 17 / 161

14
For more information visit rimage.com/support
2002760_A
Materials Task Frequency
Mandatory, continued
New fan filter Replace the fan filter . Refer
to the Replace the Fan Filter
instructions on page 16.
Monthly
Can of
compressed air
Torx T10
screwdriver
Remove dust from the system.
Refer to the
Remove Dust from
the Rimage 2000i instructions on
page 14.
Monthly
New ink
cartridges
Replace the ink cartridges. Refer
to the Replace the Ink Cartridges
instructions on page 16.
As needed
Optional
None needed Clean the ink cartridges. Refer
to the
Clean the Ink Cartridges
instructions on page 16.
When print
quality problems
are noticed
Torx T25
screwdriver
11/32" nut
driver
5/32" Allen
wrench
Align the printer. Refer to the
Align the Printer instructions on
page 18.
As needed
Note: The printer
is aligned at the
factory.
Remove Dust from the Rimage 2000i
#
Required tools:
•
Can of compressed air
•
Torx T10 screwdriver
1. Press the
recorder buttons
to open the recorder trays.
2. Power off the
Rimage 2000i
.
3. Disconnect the cables from the back of the system.
n
Caution:
Some cables in this system are latched. Equipment damage
may occur if cables are not disconnected appropriately.
• Power cord
• USB cable
4. Remove the back panel .
a. Remove the Torx T10
screws (Qty. 6) that
secure the back panel.
b. While firmly grasping
the top of the back
panel , lift and pull back
to remove it.
5. Slide the left side panel
straight back and off of
the system.
Left Side
Panel
Back Panel
USB Cable
Power Cord
Maintain the Rimage 2000i Series II