Rima RS26G, Manual, Page: 8 / 40

Page 16 of 49
4. SAWMILL HEAD ASSEMBLY
a. Place the support plate (46) horizontally and insert the two columns (47) into the appropriate position of 46.
Fix the bolts and nuts (48-1), then fix them (48-2), and then insert the steel wheel (78) into the bolts (48-2) to remove
the nuts and tighten them..
b. Place the saw head flat and insert the (46,47) assembly.
Insert the (80-1,80-2) rear post into the (46) proper hole position and fix it with four (41) bolts
c. Take 2 pieces of (51) wheel frame and 2 pieces of (52) regulating wheel and 2 pieces of (53) regulating
wheel guard plate and insert them into 2 pieces of (54) screws for fixing,
and then install the other end in the same way
b. Install the installed wheel rack left and right in the holes of the column (47)
and (80-1*80-2) and fix them with (54) bolts and nuts
c. Take (40) rear guard plate and fix 3 pieces of (41-1) bolts on the rear guard plate respectively
d. Take (43) assembly, take (41-2) screw installed in (80-2) hole, and then take (41-3 screw fixed in (40) center hole
tighten
e. Then connect the wire rope (82-1) and (82-2) and adjust the saw blade level.
f. Install the water tank rack, take (50) and (81) bolts and fix them on (80-1). Put the water tank in (50) and connect it
with 30 with a water pipe
g. Handle connection. The (55.56.57) assembly is held in place (80-2) with two (58) clips and connected to the throttle
stay (83).
h. Ruler installation. Take the ruler (35) and fix it on the back guard of the saw wheel with (84).
i.
Take the ruler base (36), fix it on (46) with two (84) bolts and adjust the clearance with the ruler before tightening it.
j. Check the screws on each part and tighten them one by one.