Riken Keiki PT2-169, Operating Manual

Page: 6 / 65

2 Important Notices on Safety 2-2. Warning cases
SD-1DGH-AS
- 6 -
WARNING
Power supply
Before turning on the detector, always check that the voltage is properly applied. Do not use an
unstable power supply because it may cause malfunctions.
Need of grounding circuit
Do not cut the grounding circuit or disconnect the wire from the grounding terminal.
Defects in protective functions
Before starting the detector, check the protective functions for defects. When seeming defects are
found in the protective functions, such as protective grounding, do not start the detector.
External connection
Before connecting the detector to the external control circuit, securely connect it to a protective
grounding circuit.
Tubing
The detector is designed to draw gases around it under the atmospheric pressure. Be sure that
excessive pressure is not applied to the sampling inlet and outlet (GAS IN, GAS OUT) of the
detector. Detected gases must be exhausted from the detected gas exhausting outlet (GAS OUT) to
which an exhaust tube is connected, to a point regarded as a safe place.
Zero adjustment in the atmosphere
When the zero adjustment is performed in the atmosphere, check the atmosphere for freshness
before beginning the adjustment. If other gases exist, the adjustment cannot be performed properly,
thus leading to dangers when the gas leaks.
Response to gas alarm
Issuance of a gas alarm indicates that there are extreme dangers. Take proper actions based on
your judgment.
2-2. Warning cases