EN
EN
EN
Whirlpool
T
LCD - Manual
IW00290.1
6.0
Protection system
If there is insufficient water in the bath, the system will not switch on in order to prevent the pumps running dry.
In addition all motors are fitted with a thermal switch. These will switch off the motors in the event of problems.
6.1
Normal temperature of bath water.
The recommended normal temperature of bath water is 38°C.
6.2
Disinfection and cleaning.
Application of (Riho) Cleaning products; Cleaning liquid, Cleaning/disinfect tablets and Soda
Whirlpool Cleaning Products are for cleaning/disinfecting the Hydro System. An Aero system blows air only and
can't/doesn't need to be cleaned with a special product.
Two products;
1. Riho Cleaning Liquid
2. Riho Cleaning/disinfect Tablets (not available in Belgium)
3. Soda
The RIHO cleaning products are mild in composition and ideal to use in our RIHO whirlpools.
During normal use of the whirlpool it is advisable to clean it every 4 to 5 whirlpool turns, interspersed with cleaning
liquid and tablets. By little use of the whirlpool, it is advisable to clean the bath in advance, so that the system is clean
before using.
1. Clean Liquid / Cleaning Fluid (part number REDIS002)
This is for the cleaning of the hydro system. You fill the tub to just above the upper jets.
Fill the clean-tank with clean liquid. The whole bottle fits in the tank and lasts for 5 cycles.
Please follow chapter 4.1.6 of this manual. After end of whole process, drain the tub and rinse with clean water.
2. Cleaning Tablets (item number REDIS001)
Cleaning Tablets are to disinfect the Hydro System.
Fit the bathtub over the top jets. Put RIHO CLEAN cleaning tablets into the tub - 1 tablet per 50 liters of water. Start
the massage system for 10 minutes, then leave the water in the tub for another 10 minutes. Run the system again for
2 minutes. Drain water and wash out the bathtub thoroughly with cold water. The bath can be used immediately after
wash out. When whirlpool is normally used, repeat cleaning once a month.
3. Major cleaning cycle with Soda
When you see black flakes in the water during the use of the whirlpool system we recommend cleaning with soda. Fill
the whirlpool just above the upper jet. Add a bag of soda to the water and make sure it is resolved because otherwise
it can cause scratches. Turn the Hydro system manually on and off (1 ½ to 2 minutes each time, repeat this 4-5 times
for good flushing of all tubes and hoses). This bath water can soak overnight so that it loosens stubborn dirt.
In the morning you repeat the process and you can empty the dirty water from your whirlpool.
For stubborn stains, the procedure may be repeated two or more times. The black flakes would be less at every turn
and eventually disappear.
W
ARNING
:
The following points are essential when using Riho Clean/Disinfection tablets and Riho Clean Plus liquid:
- Keep the products out of reach of children.
- Avoid contact with the eyes and face.
-
Do n
ot
swallow
.
- In the case of skin
/eyes/face
contact, wash with water.
- Do not inhale.
- Do not sit in the bath after these products have been added.
5.0
Whirlpool Jets
5.1
Aero jet
The aero jet has a chrome surface finish. To clean the jet, the inner part can be taken out with a small
screwdriver.
As the word Aero already indicates, this is a jet for air flow. The air swirls through the water, which gives a
relaxing effect. The air from the aero jet opening enters the bath with a certain speed. This may be
perceived as cold. The jet house itself becomes somewhat hot.
BE AWARE:
Be very careful not to damage the chrome surface.
After cleaning the jet house, the inner part can be pushed back. The inner part is clamped by an O-ring.
5.2
Hydro jets
Hydro jets have a mixed flow of water and air. This results in a powerful ray with a massaging effect. The
RIHO whirlpools and thermae whirlpools are equipped with different types of hydro jets. The type of jets
depends on the choice of the system. The functioning of all hydro jets will be described below.
ATTENTION:
Because some type of jets can be closed by turning, it is possible to close the jets while the
motor is running. Don't do this and make sure at least one closable jet is open at all times. Otherwise the
motor can get overheated because of too much pressure.
If the whirlpool
ha
s
two separate controlled
hydro
circuits,
t
h
is
remark is valid for both
circuits
.
(eg whirlpool Carmen, Lisa, Dana,...).
5.2.1
Hydro back-
, feet-
and side jet
Hydro jets have a complete chrome surface finish. The flow can be set, by pointing the opening in the
middle of the jet in the desired direction. This movement is quite heavy. Otherwise the opening would
easily turn back in its straight position, as a result of the water- and air pressure. The back and the sides
of the whirlpool have the same type of jets. The jets in the back are smaller than the ones on the side.
5.2.2
Hydro Super
jet LUX
Hydro
Super trysky LUX mají chromovou povrchovou úpravu. Síla a směr proudu může být nastavena
otáčením vnitřní části. Pokud budete otáčet vnitřní částí po směru hodinových ručiček, proud bude slábnout.
5.2.3
Thermae
SPA
rrotation jet
The outer ring of the jet has a chrome surface finish, the inside of the jet is made of white plastic. This jet
is only used in some whirlpools of Thermae line. By turning the outer ring of the jet the power of the flow
can be determined. The inner part rotates automatically, which results in a massaging effect.
5.2.4
Thermae
SPA
jet
The outer ring of the jet has a chrome surface finish, the inside is made of white plastic. This jet is only
used in some whirlpools of Thermae line. By turning the outer ring of the jet the power of the flow can be
determined. This jet produces a straight massive ray of water.
-
21
-
-
20
-
Summary of Contents for Anna BZ79005
