Rigol DG800 Series, User Manual

Page: 109 / 148

Chapter 2 Front Panel Operations RIGOL
DG800 User's Guide 2-79
Seamless Interconnection with Oscilloscope
DG800 can also seamlessly interconnect with RIGOL 's oscilloscopes that support
USB-TMC; rebuild and output the waveform data collected by the oscilloscope
losslessly. The connection method between the instruments is as shown in the figure
below.
Operation Procedures:
1. Make sure the signal under test is displayed stably on the screen of DS1.
2. Connect the USB HOST interface of DG800 with the USB DEVICE interface of
DS1 by using the USB cable. Now, DS1 will enter the remote mode
automatically.
3. Use DG800 to read the signal under test that is displayed currently on the screen
of DS1: Press Store on the front panel of DG800 to enter the store and recall
interface. At this time, the Oscilloscope menu label is displayed below the
Categories menu label, and the model identifier of DS1 will be displayed under
Oscilloscope. Tap or use the knob of DG800 to select the DS1 model identifier
to enter the seamless interconnection operation interface.
Figure 2-22 Seamless Interconnection Operation Interface
All the channels of DS1 and their on/off status are displayed at the left section of
the interface. The parameter settings are displayed at the right section of the
interface. Tap the first parameter selection field to set the data type of the
current channel to be read to "Screen Data" or "Ram Data". Tap the second
parameter selection field to set the data position (only available when data type
DG800
DS1
DS2
USB DEVICE USB HOST Output Terminal Input Terminal
USB Cable BNC Cable