LG200 Owner's Manual
Oil Change
Page 37
MTS-T4-LG200-Owners-Manual-052815
Bottom Cover of APU
Figure 21
– Bottom Cover of APU showing removable Oil Drain Plate
4. Remove the oil drain plate using a
7
/
16
" socket wrench from the bottom plate
of the engine enclosure.
5. Remove oil drain plug using a 22mm socket wrench and drain the oil.
Re-install the oil drain plug and tighten.
6. Remove the oil filter.
7. Install new oil filter.
8. Inspect drain plug gasket and replace if needed.
9. Install and tighten drain plug using a 22mm socket wrench.
10. Fill the lubricating oil system with the recommended quantity of engine oil
through the fill port.
11. Replace the oil fill cap.
12. Run the engine until operating temperature has been reached
(approximately 5 minutes).
13. Stop the engine and allow oil to drain down to the oil pan.
14. Check the oil level on the dipstick and add as necessary.
NOTE
Make sure engine is stopped, on a level grade and cool so oil has time to drain
into the sump. It is very important to use the correct grade of oil for the operating
conditions in which the unit will be working. Improper oil grade selection can
result in engine damage. Use only type CF4 - CG4 engine oil.
NOTE
Replace engine oil and filter every 1000 Hours.
Oil Drain Plate
attaches to the
Bottom Cover
of APU
