ITEM # PART #
DESCRIPTION
QTY.
A
Varies Track Assembly
1
B
52336 3/16" Aluminum Rivet Washer .198 x .510 x .067
2
C
52678 8-18X1/2 Phillips Pan Self Drill Screw
2
D
51708 M5 x 18mm (7/8") Sq/Ph/Wshr Head Wood Screw
2
E
Varies LT U-channel
1
Page 8 OF 8
K&A Manufacturing
6703 Zinser Street Schofield, WI 54476
Phone: 800.298.4351
Fax: 866.882.9475
www.raproducts.com
Instructions To Install a Track on a Series 4
Workstation:
Step 1:
Place the front of the track
A
against
the bottom of the worksurface and the back of
the track against the u-channel.
Step 2:
Align the holes in the track
A
with one
set of pilot holes in the u-channel
E
keeping
the front of the track 1/8"-5/8" from the front of
the worksurface. Place (2) washers
B
on (2)
self drilling screws
C
. Drive them through the
track and into the u-channel.
Step 3:
Attach the front of the track
A
to the
worksurface using (2) wood screws
D
. Do
not overtighten the screws. Use a low torque
setting on the power driver.
Step 4:
Complete the installation using the
instructions that came with the product you are
installing.
Troubleshooting:
If the workstation leg assemblies are at uneven heights, it is usually
caused by an improperly installed hex rod. Disassemble one of the legs from the work-
surface and make sure both ends of the hex rod are properly engaged in the hex drives
near the tops of the leg assemblies.
If you continue having problems with the table operation, contact RightAngle™
service at 800-298-4651 or [email protected].
Instruction # 53520
Side View
(Track will be at
an angle when
installation is finished.)
A
B
C
D
E
E
A
