Fax: 866.882.9475
Page 6 OF 6
Phone: 800.298.4351
K&A Manufacturing
www.raproducts.com
Instruction # 53376
6703 Zinser Street Schofield, WI 54476
Step 13:
Insert the (8) slim fix bolts
1
in the kick
panel
4
into the connector cams
2
pre-installed
in the left side panel
5
and the right side panel
6
.
You may need to move the side panels slightly to
align the bolts with the cams. Fully tighten the cam
locks.
Important note:
When tightening the cams,
they will stop at a detent in the mechanism before
they are fully tightened. Be sure to tighten them
past the detent.
14
4
10
at the top of the casters.
has casters, level it by turning the bolts
Step 14
corners of the unit. If your workstation
clockwise (from the top) on the low
Step 14:
Insert the (8) slim fix bolts
1
in the back panel into the connector
cams
2
pre-installed in the left side
panel
5
and the right side panel
6
.
You may need to move the side panels
slightly to align the bolts with the cams.
Fully tighten the cam locks.
Step 15:
Make sure all the panels are
square and level. Fully tighten the
machine screws
14
holding the side
panels to the leg assemblies
10
and
11
. Fully tighten the machine screws
12
holding the leg assemblies to the
worksurface
7
.
Step 16:
With the help of an assistant,
set the workstation upright in its final
location. Level the workstation if
required by turning the leveling glides
12
7
Glide
Toe Kick Not
Leveling
Shown For Clarity
3
Steps 15 & 16
Step 17:
Raise the top panel
9
to
its full height and slide the monitor
and the quick connect bracket
15
onto the monitor mounting plate
until it locks in place. See page 2.
Your workstation is now ready for
use.
