19
Note: Both connecting rod assemblies shown
for orientation.
DO NOT remove both at once.
Assembly of the Connecting Rod to the
Compressor
1. Line up eccentric set screw with flat on shaft.
Slide connecting rod assembly over shaft
through front of housing with eccentric toward
end of shaft. Push connecting rod assembly
tight against housing bearing.
2. Rotate eccentric to line up set screw with
access hole in bottom of housing. Tighten
screw to 125 in. lbs. Make sure the eccentric
set screw is seated perpindicular on the shaft
flat.
Set Screw
Access Hole
