12
PRELIMINARY CHECKS
First of all, carefully remove the outer packing, then:
- Remove the cardboard box, by pulling it upwards.
- Remove the protective nylon sheet.
- Disassemble and remove the protective wooden cage
using a lever to remove the staples.
- Separate the mixer from the pallet by loosening the feet
(1) and sliding off the bracket (2) securing the mixer to
the pallet.
Check that the unit is complete and undamaged. If any
defect or damage is detected, do not install or attempt to
repair the product but return it to the retailer.
Dispose of packaging in compliance with applicable law.
b
The product is supplied by the manufacturer com-
pletely screwed. The transport or a long stock may
not grant the seal. Please check the seal before the filling of the system.
b
Make sure that the installation position provides easy visibility of and access to the safety valves.
b
Connect the safety valves to a drain in conformity to applicable standards.
b
Install the product as near as practical to the storage cylinder.
b
Disconnect the product from the mains power supply before commencing any work on it.
b
The product must be installed in conformity to the laws and standards applicable in the country of installation.
b
The manufacturer’s responsibility ends with the supply of the product. The product must be installed in accordance
with industry standards by suitably qualified persons working for a company that will assume full responsibility for
the completed installation.
INSTALLATION AND PUTTING INTO SERVICE
2
1
INSTALLATION
HANDLING
The customer is responsible for providing suitable equip-
ment for unloading and moving the unit, for checking the
number of pieces delivered and for verifying the integrity
of all material.
The unit is delivered on a pallet. Use a pallet jack or forklift
truck to move the unit. Make sure that the load is perfectly
secure in order to avoid the risk of tipping presented by
the unit’s weight distribution and high centre of gravity.
Take care to avoid impacts. Move the unit to its place of
installation before removing the packing.
b
It is strictly necessary to keep a distance of 175
mm from the short sides of the pallet (as shown in
the figure) in order to avoid possible damage to the
product.
175
175
700
1050
Summary of Contents for SC ACS 160
Page 9: ...9 ENGLISH WIRING DIAGRAM ...
Page 43: ...43 ENGLISH ...
