Riello RX 150 S/PV, Installation, Use And Maintenance Instructions

Page: 36 / 56

20151674 34 GB
Maintenance
7.4 Recommended preventive maintenance programme
The use and maintenance instructions are meant for general ap-
plications. For specific use and maintenance instructions, contact
the manufacturer of the control box.
Checking components, monitor and indicators DAILY
Checking adjustments of instruments and control boxes DAILY
Checking burner flame DAILY
Checking ignition device WEEKLY
Checking flame signal strength WEEKLY
Checking flame fault control system WEEKLY
Checking firing rate command WEEKLY
Visual and acoustic control of the pilot and fuel valves WEEKLY
Checking fuel, venting, flue or inlet gates MONTHLY
Test for low updraught, fan air pressure and damper position lockout MONTHLY
Check low flame start lockout MONTHLY
High and low gas pressure lockout test MONTHLY
Recalibration of all the adjustment components SIX-MONTHLY
Check of system components for detecting flame fault SIX-MONTHLY
Check of firing rate command SIX-MONTHLY
Check of piping and cabling of all the lockouts and shut-off valves SIX-MONTHLY
Inspection of burner components SIX-MONTHLY
Flame fault detection system, test for hot refractory content YEARLY
Replacing flame rod according to the manufacturer's instruction YEARLY
Carrying out a combustion test YEARLY
Check of coils and diaphragms; testing other operating parts of the control valves and safety shut-off valves YEARLY
test of the interlocking switch of the fuel valve according to the manufacturer's instructions YEARLY
Tests for leaks on pilot valves and gas valves YEARLY
Testing air discharge switch according to the manufacturer's instructions YEARLY
Testing low flame starting lockout according to the manufacturer's instructions YEARLY
For gas burners, check the sediment well and the gas filters AS REQUIRED
Flame fault detection system, test for hot refractory content AS REQUIRED
Tab. V
Test/Inspection Frequency