Riello RS 310/EV BLU FS1, Installation, Use And Maintenance Instructions

Page: 20 / 80

20081753 18 GB
Technical description of the burner
4.14.1 List of phases
4.15 Operator panel operation
The REC37 ... control box is directly connected to the operator
panel (Fig. 9).
The buttons allow you to programme the operation and diagnos-
tics menus.
The burner management system is shown on the LCD display
(Fig. 10). To simplify the diagnostics, the display shows the oper-
ating status, type of problem, and when the problem arose.
4.15.1 Description of the symbols on the display
The brightness of the display can be adjusted from 0 ... 100%
with the parameter 126.
Phase Description
Ph00 Lockout phase
Ph02 Safety phase
Ph10 Closing paused
Ph12 Standby
Ph22 Fan motor(MV) = ON
Safety valve (VS) = ON
Ph24 The burner moves to the pre-purging position
Ph30 Pre-purging time
Ph36 The burner moves to the ignition position
Ph38 Ignition phase (TA) = ON
Ph39 Minimum gas pressure switch test (PGmin.)
Ph40 Fuel valve (V) = ON
Ph42 Ignition (TA) = OFF
Ph44 t44 = interval time 1
Ph60 Operation
Ph62 The burner moves to the switching off position
Ph70 t13 = post-combustion time
Ph72 The burner moves to the post-purging position
Ph74 t8 = post-purging time
Ph78 t3 = post-purging time
Ph80 emptying time (valve leak detection)
Ph81 Atmospheric time test (valve leak control)
Ph82 filling time (valve leak detection)
Ph83 pressure test time (valve leak detection)
Ph90 Standby time due to lack of gas
Phase Description
WARNING
➤
Observe the procedures and adjustments
shown below.
➤
All interventions (assembly and installation
operations, assistance, etc.) must be carried
out by qualified personnel.
➤ If the display and operator panel are dirty,
clean them with a dry cloth.
➤ Protect the panel from excessive tempera-
tures and liquids.
D9001
Fig. 9
Lock-out lamp
Flame presence
Valve powered
Ignition transformer
Fan motor powered
Pre-heater active
Heat request
Info mode active
Service mode active
Closure of servomotors
Opening of servomotors
Units of measurement
Lockout
Parameter mode active
only for light oil burners
V
h min s
D9000
powered
Fig. 10