Riello RS 160/EV BLU TC, Installation, Use And Maintenance Instructions

Page: 41 / 76

39
20095002
GB
Start-up, calibration and operation of the burner
6.7.2 CALC function
The diagram (Fig. 37) shows how the fuel modulation curve is
modified if the values of point “
P5 ” are changed.
By keeping the “+” key pressed for more than 3 s, the points
from “ P6 ” to “ P8 ” are recalculated.
By keeping the “-” key pressed for more than 3 s, the points
from “ P4 ” to “ P2 ” are recalculated.
The diagram of (Fig. 38) shows the fuel modulation curve when,
after the modification of point “
P5 ”, the recalculation of all the oth-
er points is not carried out.
6.7.3 Modification of parameter “acceleration /
deceleration ramp”
The burner leaves the factory with the parameters 522 (acceler-
ation) and 523 (deceleration) already set.
If the operator needs to modify them, proceed as follows:
Access the Parameters Level referring to “Access procedure
with password” on page 37.
Using the “+” key select the parameters group 500 :
Using the “+” key select the parameters group 522 (accelera-
tion) :
press the “info” key to change parameter 522 .
The set value must be greater than at least 20% of the parame-
ter “ ACCELERATION RAMP ” of the Inverter.
With the key “+”
Select the parameter 523 (deceleration) :
press the “ info ” key to change parameter 523 .
The set value must be greater than at least 20% of the parame-
ter “ DECELERATION RAMP ” of the Inverter.
P0 P1 P2 P3 P4 P5 P6 P7 P8 P9
0
10
20
30
40
50
60
70
80
90
100
Ang
le (deg
re
es)
Point of the curve
original
curve
Fu
el
CALC-
CALC+
D7908
Recalculation
Fig. 37
Fig. 38
P0 P1 P2 P3 P4 P5 P6 P7 P8 P9
0
10
20
30
40
50
60
70
80
90
100
Point of the curve
Angl
e (d
egree
s)
D7909
Fu
el
WARNING
Example:
522 at 12s ----> Inverter parameter at 10s
522 at 10s ----> Inverter parameter at 8s
WARNING
Example:
523 at 12s ----> Inverter parameter at 10s
523 at 10s ----> Inverter parameter at 8s
/reset
h min s
%
P
D9594
/reset
h min s
%
P
D9595