21
INSTALLATION
9
While operating in heating mode, the unit generates con-
densate, which will deposit on the support surface if there is
not discharge. This could freeze if the outdoor temperatures
are below zero, thus creating a hazard. In this case, appro-
priate barriers should be installed in order to prevent people
from approaching the unit.
1
Lifting from the top
2
Condensate discharge connector
1
2
MODEL 355 - 370 - 475 - 485
1
Condensate discharge connector
1
Model
250 P 355 P 370 P 475 P 485 P
Connections
Condensate
discharge
attachment Ø
16
2 x 16
mm
Hanging position
9
Properly sized supporting brackets must be used if the de-
vice is installed in suspension.
9
Ensure that the wall section does not include bearing ele-
ments, pipes or electric lines.
1
Supporting brackets
2
Anti-vibration element (supplied)
3
Fastening screw M4
1
2
3
2.9
Installation on old systems or systems in need
of upgrading
When
R
AARIA MULTI R32
is installed on old systems or sys-
tems in need of upgrading, it is recommended to ensure that:
—
the electrical system is compliant with the applicable reg-
ulations and has been installed by qualified professionals
9
In the event of a replacement, the system must be inspected
by the designer or by another competent person, and must
be compliant with the technical requirements, as well as
the current legislations and regulations.
9
The manufacturer shall bear no responsibility for any dam-
ages caused by incorrect system installation.
2.10
Refrigerating connection
The dimensions and positions of
R
AARIA MULTI R32
cooling
connections are shown hereunder.
MODEL 250
1
Gas line connection
2
Liquid line connection
3
Service connection
1
2
3
Summary of Contents for AARIA MULTI 250 P
Page 39: ......
