3150
2
GB
1.
BURNER DESCRIPTION
One stage forced draught gas burner.
1.1
BURNER EQUIPMENT
Flange with insulating gasket. . . . No. 1
Screw and nuts for flange to be fixed to the heat generator . . . No. 4
Screw and nut for flange . . . . . . . .No. 1
7 pin plug. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . No. 1
Remote reset connection . . . . . . .No. 1
1.2
ACCESSORIES
(optional):
SOFTWARE DIAGNOSTIC KIT
A special kit is available that, by an optical link to a PC, shows the burner life together with operating hours,
type and number of failures, serial number, etc. To visualise the diagnostics proceed as follows:
³
Connect the kit supplied separately to the control box socket.
Reading of the information begins when the software programme included in the kit starts.
REMOTE RESET KIT
The burner has a remote reset kit (
RS
) consisting of a connection and a push-button operating at a dis-
tance of 20 metres max.
In order to install it remove the protective lock-out installed at the factory and insert the lock-out supplied
with the burner (see electrical diagram on page 10).
MULTIBLOC ROTATION KIT
There is a special kit available that can be used to install the burner turned 180°, as illustrated on page 8 in
position 5 in the section entitled "
3.2 WORKING POSITION
". This kit is designed to ensure the gas train
valve works properly. The kit must be installed in conformity with laws and local regulations.
EXTENDED HEAD KIT
The burner’s combustion head can be replaced by the long-headed version using a special kit, to be ordered
separately. Refer to the instructions supplied with it for installation.
The kit must be installed in conformity with laws and local regulations.
1
– Pressure switch
2
– 6 pole socket for gas train
3
– Control box with 7 pole socket
4
– Reset button with lock-out lamp
5
– Flange with insulating gasket
6
– Air damper adjustment assembly
7
– Head holder assembly
8
– Pressure test point
9
– Combustion head
10
– Air damper
Fig. 1
D7180
4
3
2
1
9
8
6
5
10
7