RIEJU MR 200, Owner'S Manual

Page: 71 / 78

Troubleshooting
FAULT CAUSE SOLUTION
The damping is
too hard. Excessive fork oil level. Remove excess oil to proper level.
front fork with too much oil
viscosity. Drain the oil from the fork and refill
with an oil of suitable viscosity.
Twisted front fork. Contact the official RIEJU official
service.
Too much pressure in the tire. Check the tires pressure.
suspension poorly adjusted.
Adjust the suspension.
The motorcycle
makes abnormal
noises. Chain badly adjusted. Adjust chain tension.
Worn chain. Replace chain, front and rear
sprocket.
Worn rear sprocket teeth. Change rear sprocket.
Insufficient lubrication of the
chain. Lubricate chain with proper
lubricant.
Rear wheel misaligned. Check the tension of the spokes of
the rim.
Readjust if necessary.
Front fork spring weak or
broken. Replace front fork spring.
Brake disc worn. Replace the brake disc.
Misplaced, worn or glazed
pads Reposition the pads or change
them.
Damaged cylinder. Contact the official RIEJU official
service.
Supports, nuts, bolts badly
tightened. Check and adjust to the appropriate
tightening torques.
The handlebar
vibrates. Worn tire. Replace the tire.
Swingarm or its needle
bearings are worn. Contact the official RIEJU official
service
Offset rim. Contact the official RIEJU official
service
Wheels out of alignment. Check the tension of the spokes of
the rim. Readjust if necessary.
Steering axle with excessive
tolerance. Check steering head adjustment.
Handlebar support loose,
steering nut loose. Check and adjust to the appropriate
tightening torques.
The lamps are
melted. Defective voltage regulator. Contact the official RIEJU official
service.
The lights’
system does not
work. Connectors in bad condition,
regulator with inadequate
voltage output, check voltage
stator Clean/change connectors, check
regulator, check voltage stator.
71