RIEJU MR 200, Owner'S Manual

Page: 30 / 78

Operating instructions
DANGER
These controls are really very quick to carry
out, it is a matter of habit, the user knows the
use to which the motorcycle has been
subjected in its last use and knows where it
should this control be sharpened. Respect for
this set of controls means greater safety for the
user and, certainly, better and more economical
maintenance of your motorcycle.
Cleaning
To clean your RIEJU follow these steps:
1. Cover the exhaust system to prevent water
from entering.
2. Cover the steering lock with a piece of duct
tape.
3. Remove the mud and dirt with a low
pressure water jet.
4. Clean the areas that are particularly dirty
with a special cleaner for motorcycles.
5. Rinse with a jet of water at low pressure.
6. Let the motorcycle drain naturally.
7. Take a short ride on the motorcycle until the
engine reaches its operating temperature.
8. Lubricate the chain and all other elements
that need it (see Maintenance section).
WARNING
Never clean the vehicle using high pressure
equipment. Avoid direct contact
with
multifunction gauge, coil, pipe plug, carburettor,
switches, levers or any other electrical element.
Storage
When you have to store your motorcycle for a
period of time you should:
•
Thoroughly clean the motorcycle.
• Start the engine for about 5 minutes to
warm up the transmission oil and then
empty it (see Maintenance).
• Put in new transmission oil.
• Empty the fuel tank (if left for a long time
the petrol deteriorates).
• Lubricate the chain and all cables.
• Put oil on all unpainted metal surfaces to
prevent rust, avoiding getting oil on the
30