Drum/Base assembly (continued)
6
Screw (2 each)
Axle Retainer (2)
Axle
Retainer
Screw
(2 each)
Power Base
Wheel Caps (2)
Wheels (2)
4. Using a rubber mallet or hammer,
gently tap the wheel caps onto each
wheel center until the wheel caps are
firmly seated onto each wheel. This is
required on both sides.
2. Slide the open end of the axle through
the hole in the side of the power base
until it stops. Install the axle retainer
over the axle with the two screws
provided.
3. Repeat Step 2 for the other rear
wheel.
SP7012 Ridgid MOB16000 ESF.qxp_SP7012 12/20/16 3:33 PM Page 6
