RIDGID micro DM-100, Manual

Page: 11 / 456

micro DM-100 Digital Multimeter
10
On Product Icons
Double Insulation Symbol Fuse Symbol
Earth Ground Symbol 9V Battery Symbol
CAT III IEC Overvoltage Category III
CAT III equipment is designed
to protect against transients in
equipment in fixed equipment
installations, such as distribution
panels, feeders and short branch
circuits, and lighting systems in
large buildings.
CAT IV IEC Overvoltage Category IV
CAT IV equipment is designed
to protect against transients
from the primary supply level,
such as an electricity meter or an
overhead or underground utility
service.
Conforms to European Union
directives
Do not dispose of electrical
equipment with household
waste!
NOTICE
This equipment is used to make electrical measurements. Incorrect use or im-
proper application may result in incorrect or inaccurate measurements. Selection of appro-
priate measurement methods for the conditions is the responsibility of the user.
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reason-
able protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not in-
stalled and used in accordance with the instructions, may cause harmful interference to
radio communications.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Consult the dealer or an experienced radio/TV technician for help.
Electromagnetic Compatibility (EMC)
The term electromagnetic compatibility is taken to mean the capability of the product to
function smoothly in an environment where electromagnetic radiation and electrostatic
discharges are present and without causing electromagnetic interference to other equip-
ment.
NOTICE
The RIDGID micro DM-100 conforms to all applicable EMC standards. However,
the possibility of it causing interference in other devices cannot be precluded.
Changing/Installing Batteries
The RIDGID DM-100 Digital Multimeter is supplied without the battery installed. When the
low battery [ ] icon appears on the display screen, replace the battery. Operating
the multimeter with a low battery can cause incorrect readings. Remove the battery prior
to long-term storage to avoid battery leakage.