Ricoh SDC326, Operating Instructions Manual

Page: 54 / 107

Basic Procedure
43
2
❒
Select one of the following settings or keys:
•
[ Normal ] : normal paper
•
[ Thick ]
: thick paper, post cards, adhesive labels, translucent paper
• [ OHP ] : OHP transparencies
•
[ Duplex ]
: Use for copying onto the reverse side of paper that has been al-
ready copied onto.
⇒
P.49 “Copying onto the reverse side of paper” .
• [ Duplex Thick ] : Use for copying onto the reverse side of thick paper (105-
160g/m
2
, 28-43 lb) that has been copied onto.
⇒
P.49 “Copying onto the re-
verse side of paper” .
•
[ Custom ]
: Use to specify a custom sized.
⇒
P.45 “Copying onto custom size
paper with the bypass tray” .
❒
If the copy paper is bent, correct it before setting paper in the bypass tray. If
the bend is not corrected, a paper misfeed might occur.
❒
When you copy onto OHP transparencies, you can select whether a blank slip
sheet is inserted between OHP transparencies.
❒
When you set several sheets at a time, fan them to get air between them before
loading.
❒
If the copy paper is curled, gently roll it to remove the curl.
❒
When you copy onto OHP transparencies, insert them with the copy side up.
❒
Do not stack copy paper above the limit mark.
❒
When setting custom size paper, be sure to set the size after pressing the
[ Cus-
tom ] key.
Copying onto standard size paper with the bypass tray
Note
❒
When you copy onto the reverse side of paper that has been already copied
onto,
⇒
P.49 “Copying onto the reverse side of paper” .
Gchyoh1e.eps